
42 Command Summary
ID Type X Y Width Height Control Width Min Max
ID Type X Y Width Height Control Width Min Max
ID Type X Y Width Height Control Width Min Max
Draw a slider on the screen that responds visually and numerically when tapped or slid. Slider regions respond
with a value of 83, their ID, then two byte length current X and Y coordinates when activated.
Unique slider identification number, maximum 32 regions/sliders. value between 0 and
31
Defines slider direction and starting point for the control, as below.
Width of the slider control.
Table 35: Slider Definition
Horizontal slider, starting at minimum position
Vertical slider, starting at minimum position
Horizontal slider, starting at maximum position
Vertical slider, starting at maximum position
Horizontal slider, starting at middle position
Vertical slider, starting at middle position
Deletes a previously created slider. Memory is shared with touch regions, this command will free space.
Unique region identification number.
Deletes all previously created sliders. Does not remove touch regions.
11.9 Set
Dragging
Threshold
Threshold
Threshold
Threshold
Sets the distance a press is required to travel before a drag event is reported. Precision will vary inversely to data
transmitted; care should be taken to find a suitable balance. Distance is calculated as
.
Dragging threshold value. Default is 8.
Comentarios a estos manuales