Matrix-orbital LK202-25 Legacy Manual de usuario descargar pdf (Pagina 7)

LK202-25 rev 3 7

1.7 To Reset the module

Manual override should only be required in one instance. If for some reason the module is set at a baud

rate which cannot be produced by the host system and all communication to the display is lost, then the

user should follow this simple procedure:

1. Turn off the display

2. Put a jumper on pins 5 and 6 of the keypad connector (C5 and R1).

3. Power up the display. The baud rate is now set to 19,200.

4. Remove the jumper and change the RS-232 port settings to the desired baud rate.

5. Turn off the display.

6. Power up the display.

Refer to the “Set RS-232 Port Speed” command (section 6.1.12) for acceptable baud rates.

1 2 3 4 5 6 7 8 9 10 11 12 ... 36 37

Sin comentarios

Matrix-orbital LK202-25 Legacy Manual de usuario Pagina 7