Matrix-orbital GLK24064-25 Legacy Manual de usuario descargar pdf (Pagina 42)

Examples When the key code associated with key ’P’ (0x50) is pressed, the release

code is ’p’ (0x70). In RS-232 polled mode or via the I

C, the “Key

Down / Key Up” codes are used; however, the user should be careful of

timing details. If the poll rate is slower than the simulated auto-repeat it

is possible that polling for a key up code will be delayed long enough

for an unwanted key repeat to be generated.

9.8 Auto Repeat Mode Off

Syntax

Hexadecimal 0xFE 0x60

Decimal 254 96

ASCII 254 “‘”

Description This command turns auto repeat mode off. See Set Auto Repeat Mode.

Remembered No

9.9 Assign Keypad Codes

Syntax

Hexadecimal 0xFE 0xD5 [KDown] [KUp]

Decimal 254 213 [KDown] [KUp]

Parameters

Parameter Length Description

KDown 25 Key down codes

KUp 25 Key up codes

Description This command will allow you to reassign the key codes that correspond

to the key presses on the matrix style key pad. The ﬁrst 25 bytes that are

transmitted will be used for the key down codes and the next 25 bytes

that are transmitted will be used for the key up codes.

Key Down

1 2 3 4 5

1 A B C D E

2 F G H I J

3 K L M N O

4 P Q R S T

5 U V W X Y

Key Up

1 2 3 4 5

1 a b c d e

2 f g h i j

3 k l m n o

4 p q r s t

5 u v w x y

Remembered Always

Matrix Orbital GLK24064-25 37

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 67 68

Sin comentarios

Matrix-orbital GLK24064-25 Legacy Manual de usuario Pagina 42